--- title: "3.13 Inputs Configuration" slug: "ac-detect-digital-and-analog-inputs" updated: 2025-10-17T18:14:38Z published: 2025-10-17T18:14:38Z canonical: "knowledgebase.morningstarcorp.com/ac-detect-digital-and-analog-inputs" stale: true --- > ## Documentation Index > Fetch the complete documentation index at: https://knowledgebase.morningstarcorp.com/llms.txt > Use this file to discover all available pages before exploring further. # 3.13 Inputs Configuration ## Modify Network Settings Using Morningstar Mobile App These settings are currently only configurable using LiveView. See instructions below. ## Modify Inputs Settings Using LiveView ## Digital Inputs The ReadyEdge has six(6) Digital Input connections. Digital Inputs detect low-resistance, “dry contact” open/close circuit signals. The ReadyEdge detects whether the digital input is in the open state or if the input is shorted , aka the closed state. Devices like smoke detectors, door sensors, or even a simple mechanical switch can be connected to a digital input. Each input is assigned a custom name and programmed to set Alerts on specific events. > ![](https://cdn.document360.io/5c3867fe-b3a6-44b5-80c7-4bc7662cc267/Images/Documentation/Note(1).png) ***NOTE****:* A Digital Input may be used as the AGS generator feedback signal, but only **Digital Input 1** may be used for this purpose. **Step 1** For each input, specify a custom text label. This short descriptor will be used throughout the ReadyEdge user interface. **Step 2** Set the Alert condition as follows: | Never | no alert is sent when the Digital Input changes state | | --- | --- | | On Active | alert is sent when the input changes from open to shorted | | On Inactive | alert is sent when the input changes from shorted to open | | On Change | alert is sent each time the input changes state (open to short, short to open) | **Step 3** Enable/Disable Auto-clear alerts. | Disabled | An alert condition is set when the Alert Condition becomes true (On Active or On Inactive) and remains set until the user manually clears the Alert. | | --- | --- | | Enabled | An alert condition is set when the Alert Condition becomes true (On Active or On Inactive) and automatically clears when the alert condition is no longer true. This setting does not apply to “On Change” condition. | Alerts can be manually cleared in the following ways: 1. Use the LiveView dashboard Digital Inputs card: Click the “Clear” button next to the corresponding digital input (see screenshot below) 2. Send a MODBUS coil write command to the Clear Alert register 3. SNMP set of the clearAlert OID ![](https://cdn.document360.io/5c3867fe-b3a6-44b5-80c7-4bc7662cc267/Images/Documentation/image(101).png) ## DC Inputs Assign short descriptions to each DC voltage measurement used. This short descriptor will be used throughout the ReadyEdge user interface. ![](https://cdn.document360.io/5c3867fe-b3a6-44b5-80c7-4bc7662cc267/Images/Documentation/image(102).png) ## Tank Sensor **Step 1** Choose between the SAE/North American or European resistive tank sensor standard. **Step 2 - Optional** Set an Alert threshold for low tank level ![](https://cdn.document360.io/5c3867fe-b3a6-44b5-80c7-4bc7662cc267/Images/Documentation/image(103).png) ### Remote Temperature Sensors Assign short descriptions to each temperature measurement used. This short descriptor will be used throughout the ReadyEdge user interface. ![](https://cdn.document360.io/5c3867fe-b3a6-44b5-80c7-4bc7662cc267/Images/Documentation/image(104).png) ## ### ###