--- title: "Step 2: Connect Digital Inputs" slug: "digital-input-connections" updated: 2025-07-15T22:30:54Z published: 2025-07-15T22:30:54Z canonical: "knowledgebase.morningstarcorp.com/digital-input-connections" --- > ## Documentation Index > Fetch the complete documentation index at: https://knowledgebase.morningstarcorp.com/llms.txt > Use this file to discover all available pages before exploring further. # Step 2: Connect Digital Inputs > [!WARNING] > ![](https://cdn.document360.io/5c3867fe-b3a6-44b5-80c7-4bc7662cc267/Images/Documentation/Caution(1).png) ***CAUTION****: The grounding polarity of all Digital Inputs MUST match the grounding polarity of the ReadyEdge power source.* > > > > ![](https://cdn.document360.io/5c3867fe-b3a6-44b5-80c7-4bc7662cc267/Images/Documentation/Caution(1).png) ***ATTENTION****: La polarité de mise à la terre de toutes les entrées numériques DOIT correspondre à la polarité de mise à la terre de la source d'alimentation ReadyEdge.* ![](https://cdn.document360.io/5c3867fe-b3a6-44b5-80c7-4bc7662cc267/Images/Documentation/image(45).png) Digital Inputs location and polarity (termination plug not shown for clarity) The ReadyEdge has six (6) Digital Input connections for signal monitoring and triggering user defined alerts. Each input accepts a “dry contact” signal from a third party device. Example devices include: - Door Sensors - Theft Loops - Smoke Detectors - Mechanical Switches - Circuit breaker open/close contacts - Tank float switches - Relay contacts (the relay coil activated by a DC or AC power source) - Power supplies, fuel cells, and other devices with Alarm output dry contacts Each Digital Input reports a “Yes” or “No” status corresponding to an open-circuit or short-circuit condition. Input status can be monitored, used as a variable for conditional logic, and for triggering Alarms. See 3.7.14 Alarms Configuration for more details. #### Wiring Instructions 1. Connect the sense wires from the device being monitored to a ReadyEdge Digital Input port. > [!WARNING] > ![](https://cdn.document360.io/5c3867fe-b3a6-44b5-80c7-4bc7662cc267/Images/Documentation/Caution(1).png) ***CAUTION****:* If one leg of the sense wires is grounded, the grounding polarity MUST match the grounding polarity of the ReadyEdge power source. > > > > ![](https://cdn.document360.io/5c3867fe-b3a6-44b5-80c7-4bc7662cc267/Images/Documentation/Caution(1).png) ***ATTENTION:*** *Si une branche des fils de détection est mise à la terre, la polarité de mise à la terre DOIT correspondre à la polarité de mise à la terre de la source d'alimentation ReadyEdge.* 2. Insert the sense wires into the spring clamp terminal connector 3. Clamp the wires securely into place 4. Repeat for other devices 5. Insert the terminal block plug into the terminal socket on the ReadyEdge labeled “Digital Inputs”