--- title: "Step 8: Ethernet Connection" slug: "ethernet-connection" updated: 2025-07-14T15:36:24Z published: 2025-07-14T15:36:24Z canonical: "knowledgebase.morningstarcorp.com/ethernet-connection" --- > ## Documentation Index > Fetch the complete documentation index at: https://knowledgebase.morningstarcorp.com/llms.txt > Use this file to discover all available pages before exploring further. # Step 8: Ethernet Connection ![](https://cdn.document360.io/5c3867fe-b3a6-44b5-80c7-4bc7662cc267/Images/Documentation/image(49).png) Ethernet Port #### Option 1: Connect to Your Local Area Network (LAN) 1. Connect the ReadyEdge Ethernet port to the local network router using the included Ethernet cable or any standard Ethernet cable. 2. Your network should automatically connect to the network once the ReadyEdge is powered on (the last step of 2.0 Installation). The ReadyEdge Ethernet mode is configured for DHCP by default and will automatically attempt to obtain an IP address from your network host once it is powered on and connected to a network. A successful Ethernet connection is required to configure the ReadyEdge system settings and access device data using the LiveView web app. If the ReadyEdge does not receive a DHCP-assigned IP address from a network host it will attempt to use its default static IP address of xxx.xxx.x.x. #### Option 2: Connect Directly to a PC (less common) Alternatively, the ReadyEdge can be connected directly to a PC over Ethernet for initial setup if no network access is available. Please refer to our [Morningstar Product Connectivity Manual](https://www.morningstarcorp.com/wp-content/uploads/technical-doc-morningstar-product-connectivity-manual-networking-communications-en.pdf) for additional instructions on connecting Ethernet enabled Morningstar devices directly to a PC or to local area networks.