--- title: "Step 10: Power-Up and Verification" slug: "final-connections" updated: 2025-07-14T15:46:06Z published: 2025-07-14T15:46:06Z canonical: "knowledgebase.morningstarcorp.com/final-connections" --- > ## Documentation Index > Fetch the complete documentation index at: https://knowledgebase.morningstarcorp.com/llms.txt > Use this file to discover all available pages before exploring further. # Step 10: Power-Up and Verification See [1.2 Product Features](/docs/features-exterior-and-interior#feature-callouts) to reference LED type and location After the ReadyEdge has been installed, the unit with connect with Ethernet and LiveView after connecting the power supply. See [Power In Battery Connections](/docs/power-in-battery-connections) for more information. If there are no faults or alarms, on start-up the status LED will flash green once, and then all LEDs will light green simultaneously for three seconds. Next, the ReadyEdge will automatically begin searching for valid Morningstar Devices. | ## Major LED Indications | | --- | | Status LED (Top LED) | | Green-solid | No Local or Remote faults | | Green-flashing | Recovery Firmware Update | | Red-solid (heartbeat) | Active ReadyEdge Fault | | Red-flashing | Active Remote (Connected Morningstar Device) Fault | | Bluetooth LED | | Unlit | OFF | | Blue-solid | Bluetooth Enabled | | IOT Connectivity | | Unlit | Not Connected | | Green-solid | Cloud Connected | | Ethernet Connectivity | | | Ethernet power and network activity | | Read Only Mode* | | Green-solid | Read-Only Mode OFF - Ethernet writes enabled | | Red-solid | Read-Only Mode ON - Ethernet writes disabled | > ![](https://cdn.document360.io/5c3867fe-b3a6-44b5-80c7-4bc7662cc267/Images/Documentation/Note(1).png) ***NOTE****:* The ReadyEdge is shipped with Read Only Mode off, indicated by a green light on the 4th LED (unlock icon). Ready Only mode must remain disabled to configure the ReadyEdge in LiveView. Read Only Mode is controlled by DIP Switch 1. Proceed to [3.0 Configuration](/docs/commissioning) to adjust settings and finish setup.