3.16 Adjusting Schedules

  • Published on Oct 17, 2025
  • 1 minute(s) read
Prev Next

Schedules can only be created and edited in LiveView. Use the Schedules Page to define and/or modify schedules for ReadyRelays and Automatic Generator Start.

About Schedules

Schedules define time blocks and days of the week based on the ReadyEdge internal real-time clock or network time if configured. Schedules will be visible on this page if the following conditions are met:

  • AGS must be assigned to “Custom” mode for schedules to appear on this page

  • ReadyRelay relays must be assigned to “Command/Schedule” for schedules to appear on this page

Relay Schedules

Define when a relay is on/off

AGS Charging Schedules (Custom Mode only)

Define hours of generator operation, paired with START and STOP criteria. The generator may run during the scheduled hours, but only if the START condition becomes true. The generator will stop at the end of the schedule, or sooner, if the STOP criteria becomes true. Navigate to the AGS tab under the Setup menu to create or edit the AGS START/STOP criteria.

Step 1 Choose a Schedule to Edit

The schedules list is on the left side of the screen as shown in the red box in the screenshot below. Select a schedule to edit.

Step 2 Configure the Schedule Routines

A Routine defines the beginning and ending time when a relay or AGS schedule will be active, and on which day(s) of the week. Combine up to four (4) Routines in a single schedule to create comprehensive times of operation throughout the week. The Routine configuration is shown in the red box in the screenshot below.

  1. Select which day(s) of the week the Routine should be active.

  2. Select a beginning and end time for the time block. If the Routine should run the entire 24hrs that day, check the “All Day” checkbox.

  3. Check additional Routines on the list, configure as needed to build your schedule.

 NOTE: If the ending time of a Routine is past midnight, the time block will extend into the following day as necessary.

Step 3 Save Your Work

Remember to save your changes when complete! Click the Save button in the upper right as shown below.