Step 10: Power-Up and Verification

Prev Next

See 1.2 Product Features to reference LED type and location

After the ReadyEdge has been installed, the unit with connect with Ethernet and LiveView after connecting the power supply. See Power In Battery Connections for more information. If there are no faults or alarms, on start-up the status LED will flash green once, and then all LEDs will light green simultaneously for three seconds. Next, the ReadyEdge will automatically begin searching for valid Morningstar Devices.

Major LED Indications

Status LED (Top LED)

Green-solid

No Local or Remote faults

Green-flashing

Recovery Firmware Update

Red-solid (heartbeat)

Active ReadyEdge Fault

Red-flashing

Active Remote (Connected Morningstar Device) Fault

Bluetooth LED

Unlit

OFF

Blue-solid

Bluetooth Enabled

IOT Connectivity

Unlit

Not Connected

Green-solid

Cloud Connected

Ethernet Connectivity

Ethernet power and network activity

Read Only Mode*

Green-solid

Read-Only Mode OFF - Ethernet writes enabled

Red-solid

Read-Only Mode ON - Ethernet writes disabled

 NOTE: The ReadyEdge is shipped with Read Only Mode off, indicated by a green light on the 4th LED (unlock icon). Ready Only mode must remain disabled to configure the ReadyEdge in LiveView. Read Only Mode is controlled by DIP Switch 1.

Proceed to 3.0 Configuration to adjust settings and finish setup.