Step 4: 12 Volt Power Out Wiring

Prev Next

 CAUTION: Equipment Malfunction

12 Volt Power Output is switched in the positive leg. If the ReadyEdge input power source is positive grounded, the 12 Volt Power Out circuit must not be grounded.

   ATTENTION: Panne d'équipement

La sortie de puissance 12 volts est commutée sur la borne positive. Si la source d'alimentation d'entrée ReadyEdge est mise à la terre positive, le circuit de sortie 12 volts ne doit pas être mis à la terre.

 NOTE: The 12 Volt Power Out is designed to provide power for specific applications as noted in this section. It should not be used to power load circuits where surges, current in-rush, or over-currents are possible. These conditions will result in nuisance tripping of protections and loss of power to the load(s).

 REMARQUE: La sortie 12 volts est conçue pour fournir de l'énergie pour des applications spécifiques comme indiqué dans cette section. Elle ne doit pas être utilisée pour alimenter des circuits de charge où des surtensions, des appels de courant ou des surintensités sont possibles. Ces conditions entraîneront des déclenchements intempestifs des protections et une perte de puissance vers la(les) charge(s).

12 V Power Out Port

The 12 V Power Out port features a removable termination plug with compression screw terminals. It may be convenient to remove the plug, make the wiring connections, and then reinsert the plug in the location shown in the illustration above. The output port provides a 12 Volt power supply at a maximum of 1 Amp.

Wiring Instructions by Application

  1. Power an EIA-485 network - Refer to Step 9B: Connecting Devices Using EIA-485 network

  2. Signaling a generator to start/stop - Refer to Step 7: Automatic Generator Start (AGS) Wiring Examples

  3. Driving a 12 Volt dc relay coil to switch larger DC or AC loads

    1. Connect the 12V Out ± wires to the relay coil terminations. The relay coil must be nominal 12 Vdc. Observe correct polarity.